What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 03:02

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What is Quora? Are there any tips?
The MOV will conduct when the voltage exceeds 50% of line voltage.
A fuse is a non-resetable over current circuit protector.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
What do you think of the Quora group "It's Ok to Be White" for people who are proud of being white?
a photo is worth a thousand words.
One
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This device then solves the entire problem.
How the Menstrual Cycle Affects ADHD - The Cut
(Dc diagram shown, AC is similar).
One is “what exactly is in a ‘surge protector’ ? ”
He then describes Rainy Season and Lightning.
At least they know the answer if they wanted it.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This one hit behind the barn.
At one ohm, the resistor has a maximum of 1 watt power.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
An AC voltage/ current source, and an ac inductive load.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Where should Jac Caglianone hit in the Royals order? - Royals Review
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Now when you have a certain ac resistance, then a current flows in a loop.
[old diagram got deleted by accident]
DNA from 9,000-year-old skeletons disproves migratory waves theory from South Africa - Earth.com
These devices are installed between the “hot” and “neutral” and protective ground.
The third is lightning and “how it gets conducted into a home.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
People’s Pharmacy: Did this OTC allergy medicine cause my excruciating knee pain? - OregonLive.com
This is where the MOV conducts again, and dissipated the energy.
nine
In schematic diagrams this is the symbol for a fuse:
The two rules investors need to follow right now as the S&P 500 eyes a return to 6,000 - MarketWatch
Because the load is inductive, the current lags the voltage.(by a bit).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
First Sentence:
eight
so, what happens?
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is 'the assistant's answer'
[image of Common-mode choke]
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Barnstars:
I post the exact comment here.
Here is a simplified AC power diagram.
What does a fuse do?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
For this case there are devices called Metal oxide varistors (MOV).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but this device (an Inductor) … impedes the rapid changes in the current.
What is lightning?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It seems Mohan does not understand the difference between a comment and an Answer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
the problem then depends on "how fast does the fuse operate?".
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
what exactly is a ‘surge’ protector?
It also is a device that limits the change in current flow.
A circuit breaker is similar, but is resettable.
He then asserts :
Edit 2024–10.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–10[John johnson John Johnson ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
but I think this circuit , shows a few more pieces.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But… the neutral is now “floating” because of the 1 ohm resistance.
There are three different concepts here that are getting confused.
He then describes the function of a fuse.
The other is “what does a “fuse” do?”
These are simplified answers to the original question, and does not change anything I wrote above.
There are two important concepts here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Upvotes:
This is the picture of an electronic coil of wire wound around a core of magnetic material.